The servo is connected to pin 11.
Open and closed a servo door lock.
If key key if the lock is open it can be locked again by pushing o r on the keypad.
If the state changes from low to high the door opening event is detected.
Bluetooth door lock arduino.
Bend one of the paperclips and fold out the other one as straight as possible.
Recently i rewatched the amazing spiderman in one scene peter parker locks and unlocks his door from his desk using a remote.
After a bit of tinkering i got a working model.
When you insert the bent paperclip stick the straightened paperclip beneath it and move it around.
This operation can be used to actuate a door lock or a latch to enable you to remotely lock and unlock a door or gate.
After some wiggling your lock will hopefully open.
The required circuit is a simple pulse generator based on a 555 timer arduino or pic microcontroller.
Heres how i made it.
To detect the door opening door closing events we can detect the state change on the arduino input pin.
If the state is high the door is open.
Servo at 0 position door is closed.
It will open door and send confirmation message otherwise it will send alert message.
Arduino uno mega x1 breadboard x1 4 4 keypad x1 servo motor x1 red led x1 green led x1 220 ohm x2 jumper cable code listing is here on arduino door lock.
If you have two paper clips on you the process will be that much easier.
When i saw this i instantly wanted my own for my door.
The command to close the lock after or is pushed.
In this project we will do an automatic door lock system using a 4 4 keypad and servo motor controlled by arduino.
Void loop char key keypad getkey.